Current position > News detail
『Instantaneous flow rate of vortex flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
Why does Rosemounts vortex flowmeter not display instantaneous flow rate, but display cumulative flow rate? _Baidu ...
Are you referring to the screen not displaying? The instrument can be displayed through parameter settings. If the instantaneous flow is zero, but the cumulative flow continues to accumulate, it may be due to a small flow cutoff. In this case, the instrument will filter out very low flow signals to avoid inaccurate instantaneous flow caused by signal interference. There is no need to worry too much about normal signal interference, as there is no actual time record and the accumulated traffic can only be used as reference data. When the instantaneous flow rate is not displayed, the parameter settings of the instrument can be checked to ensure its correct configuration. If the settings are correct but the problem still appears, it is recommended to check the connection and power status of the instrument. Sometimes, instrument display issues may be related to hardware or software failures. If the problem persists, it is best to contact the manufacturer or professional technicians for further diagnosis. In practical applications, the display of instantaneous flow rate and cumulative flow rate of vortex flowmeter may be affected by various factors. Signal interference is one of the common causes, especially in industrial environments. In order to ensure the accuracy of data rows, the instrument usually sets a threshold. When the instantaneous flow rate is below this threshold, the system may automatically cut off this part of the data and only display the effective flow rate. This helps to reduce erroneous data caused by interference. For the situation where the instantaneous flow is zero and the
2. How to deal with the display of overrange in a vortex flowmeter
The core solution for the display of overrange in a vortex flowmeter is to first troubleshoot temporary faults, then locate hardware or parameter issues, gradually solve them, and then restore normal measurement.
. 1. Temporary emergency troubleshooting steps: First, quickly deal with display abnormalities caused by exceeding the range to avoid affecting production or measurement. 1. Cut off the instantaneous flow signal: temporarily close the valve upstream of the flowmeter to stop the fluid flow, and observe whether the displayed value drops back to the normal range. 2. Restart the equipment: disconnect the power supply of the flowmeter, wait for 10-30 seconds, and then power it back on. Some false exceedance caused by signal interference will automatically recover. 3. Check the pipeline operating conditions: co