Current position > News detail
『3-wire flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
What is the price of an electronic flowmeter?
2. Solve the problem of the diesel flow meter.
The three wires should be pulse signals. Use a multimeter to measure and find the positive and negative terminals of the power cord. The other wire is the signal wire. Remove the signal wire and repeatedly touch it with the positive terminal of the power cord to increase the fuel consumption meter reading.. (Note that the sensor to be touched is the fuel inlet, do not handle the return oil, and you can also remove the signal line of the return oil sensor to increase fuel consumption)
3. What are the communication protocols for German Sick flow meters
German Sick flow meters mainly use the following communication protocols
1. IO Link uses IO Link V1.1 version, such as SICK gas flow meter FTMG-ISD15AXO model.
. This protocol supports simple system integration and real-time data transmission, suitable for device level communication2. The Ethernet protocol suite is based on Ethernet interfaces and includes three protocols: • REST-API: data transmission through HTTP requests • MQTT: lightweight publish/subscribe mode communication • OPC-UA: supports cross platform industrial automation communication These three protocols can achieve complete measurement data transmission, especially suitable for energy monitoring and system integration scenarios
3. The Modbus FLOWSIC600-XT series supports multiple variants: • Modbus TCP (Ethernet) • Modbus RTU RS-485 (3-wire system) • Modbus ASCII RS-485 (3-wire system) provides flexible fieldbus integration solutions
4. HART protocol The FLOOSIC600-XT series has dual functions with a HART interface: • HART master station: connects ext
_600x400.jpg)
4. Wiring method of flowmeter
The wiring method of flowmeter may vary depending on different types and brands.
. Here are two common wiring methods for flow meters for your reference.1. Wiring method for split type flow meters: As shown in the above figure, the sensor and accumulator of the split type flow meter are installed separately and connected through signal cables. When wiring, it is necessary to connect the output signal of the sensor to the input terminal of the integrator. Generally speaking, the wiring method of a split type flowmeter is relatively simple. Simply connect the corresponding signal line to the integrator.
2. Wiring method of an integral flowmeter: As shown in the diagram, the integral flowmeter integrates the sensor and integrator together without the need for signal cables.
. When wiring, it is necessary to connect the output signal of the sensors dead end finger to the input terminal of the integrator. The wiring method of the integral flowmeter is relatively simple, just connect the corresponding signal line to the accumulator. It should be noted that different types of flow meters have different wiring methods, so it is necessary to carefully read the u